SmallHD 503 Monitor Bracket to 15mm x 60mm Bars
Strong and rigid but weighs just 68grms (2oz)
Clamps securely onto 15mm bars
Constant-friction pivot for easy monitor positioning
This is the ‘SmallHD503 to 15mm bars’ bracket which is used to mount the SmallHD 503 Ultrabrite monitor onto any standard (60mm pitch) 15mm bars.
Allows you to firmly mount the monitor at the front of the steadicam's stage, primarily as a secondary monitor for low mode use.
It is lightweight, rigid and has a ‘constant friction pivot’ so the monitor can be tilted without loosening the thumbwheels. You simply screw down the thumbwheels to select the required friction and you’re good to go.
Screws into the back or base of the monitor.
To make this bracket, you will need to buy all the parts in this list.
Click on each item to go directly to that part on the Shapeways 3D printing site and put it in your basket.
Once you have all the parts in your basket, go to the checkout for the total price.
3. TWA22 (you will need two of these)
6. CP222HD (you will need two of these)
To complete the bracket you will also need;
One 1/4 UNC half-height hexagonal nut (only a 4mm high half-nut will fit)
In the UK, I have found Westfield Fasteners a good source for UNC nuts and bolts and the links above are to their site.
TWO IMPORTANT NOTES BEFORE YOU START
Sometimes slight 3D printing variation means that the fit of the bolts in the printed holes is a little too tight.
If this is the case and the fit is a little too stiff then just widen the hole slightly by pushing a 1/4" bolt back and forth through the hole until it can slide easily.
When you slide the bolts into the thumbwheels, ensure the bolt head is sat all the way down at the bottom.
Sometimes there can be a small build up of excess printing powder on the inside corners of the thumbwheel, so if that’s the case, just scrape it away before you put the bolt in. This will ensure enough room for the cap to snap into place.
OK ALL SET TO GO ………………..
Refer to the exploded view and the part pictures (below) for a guide as to how it all goes together.
1. Slide the thumbwheel with the dovetail base (Part TWB22) into the slot in the ‘paddle’ (Part PADSMA) until the holes align and then push through the 1/4” UNC x 5/8” bolt.
2. Push the 1/4” UNC x 2” bolt through one of the remaining thumbwheels and use it to fix the ‘paddle’ to the BS1560 base.
3. Push the 1/4” UNC half-nut into the remaining thumbwheel and screw it onto the end of the 2” bolt.
4. Each of the thumbwheel caps has 3 small sawtooth catches which latch into the sawtooth holes in the thumbwheel body so before pushing the caps into the thumbwheels, make sure that the sawtooth and its corresponding hole is aligned.
Also, make sure that cap CP122NT is the one which is used at the nut end of the main pivot and the other two caps are used at the bolt-head ends. NT for ’Nut’ HD for ‘Head’
The caps are fitted by lining them up squarely and pushing them firmly into the thumbwheel body. If this is not done squarely then there is a chance that the caps's lugs could be damaged. This is not the end of the world but you would probably then need to use some superglue to ensure the cap stays attached.